In this edition of Voices of the Industry, Mike Crovo, General Manager of Viking Integrated Safety, discusses the importance of using early warning thermal sensors to enhance fire protection in data centers.
Fire protection systems for modular and edge data centers typically use spot smoke detectors to identify possible threats as quickly as possible. Aspirating smoke detectors (ASD) may be used for very early smoke detection in the incipient stage of a fire. Gas detectors may be used where batteries (i.e. lithium-ion) are deployed. Even with the best of these fire safety detectors, the precise location & source of the potential threat is difficult to pinpoint, especially in high airflow environments, where smoke and gasses can be quickly transported away from the source.
What are the principal fire threats in most modular & edge data centers?
- Electrical feeds including PDUs, transformers, & inverters — short-circuits, electric overloads, power & grounding faults
- Batteries & UPS — overheating & thermal runaway
- Mechanical systems — AC & ventilation system anomalies & failure
- Leaks — water, battery electrolytes, fuels
In most cases, abnormal equipment heating precedes the presence of smoke or gas. To detect this overheating, early warning thermal imaging sensors, like those from ServersCheck, can monitor and detect a variety of threat conditions that, if left unchecked, could lead to a fire. These sensors do not replace fire safety systems — they complement them well by pinpointing the source, providing additional time to investigate a potential threat before it can escalate.
Traditional temperature sensors measure the air temperature near the target equipment, limiting their effectiveness for detecting overheating. Thermal imaging sensors record 2-dimensional images of surface temperatures on the target equipment. This is important for precisely locating the source of the overheating.
Since thermal imaging sensors detect light in the infrared range (IR), they need no visible light for analysis and are ideal in dark enclosures. The thermal images produced by the sensors provide an image with colors ranging from black to blue, red, and yellow indicating increasing temperatures. Abnormal hot spots on the equipment can easily be identifies, as well at the intensity.
Portable (i.e. hand-held) thermal imaging equipment has been used for years for installation surveys and periodic inspections of electrical switchgear, IT equipment, PDU, and UPS modules. Indeed, these inspections may be required before a data center becomes operational. However, data centers need to be available 24/7/365, so continual monitoring with thermal imaging sensors is more appropriate for fire safety.
Besides fire prevention, thermal image sensors can also improve equipment uptime and prevent failure with early warning of potential overheating. Additionally, thermal imaging can assist with cooling and ventilation tuning to direct airflow to potential hotspots in the data center enclosure.
As an example, ServersCheck thermal imaging sensors will monitor up to 19,200 individual points every 2 seconds with varying fields of view (FoV) and temperature accuracy. A variety of equipment ranging from electrical panels, to switch gear, PDUs, UPSs, and even server racks can be monitored to provide very early detection of potential fire threats.
The sensors are networked and powered by PoE with temperature data delivered continually to a building management system (BMS) or industrial and IT automation platforms via Modbus TCP, RTU (RS485), or SNMP.
In the accompanying image, a PDU is being monitored by a thermal imaging sensor sensor at
Sensors with lower resolutions can be used to monitor batteries, automatic transfer switches (ATS), and uninterruptible power supplies (UPS). The earlier recognition of thermal irregularities can prevent problems before they lead to more expensive system failures.
Early warning thermal imaging sensors are enhancing fire safety, especially in unmanned critical infrastructure like modular and edge data centers. These sensors can monitor rapid temperature changes that have often gone undetected in the past. Their inclusion in a fire protection system can help avoid catastrophe and ensure operational continuity.
Mike Crovo is the General Manager of Viking Integrated Safety and has 15+ years in business development, sales, and executive roles for Viking, Honeywell, Jensen Hughes, Xtralis and other leading fire safety companies.